Lost Vape Centaurus BT200 | set up for flavour

A 200 W box mod is usually sold on its vapour, rarely on what it does to an e-liquid. The Lost Vape Centaurus BT200 follows the pattern, and its product pages mostly talk about Bluetooth, a colour screen and coils built for big clouds. For a notebook that reads every puff as attack, mid-palate and finish, the question is a different one. Which settings genuinely shape flavour, and on which tank does this mod let a recipe speak?

Is the Lost Vape Centaurus BT200 a good mod for tasting?

Yes, with one condition. The Lost Vape Centaurus BT200 is a dual-battery box mod running two external 18650 cells, adjustable from 5 to 200 W according to the manufacturer. Its low end, its temperature control and its adjustable power curve make it a base that can serve a recipe with real precision.

The condition is the tank. The one in the kit, the Centaurus Sub Ohm V2, only takes coils from 0.15 to 0.3 ohm designed for direct lung vaping at high wattage. It favours vapour over aromatic detail.

To read an e-liquid stage by stage, there are two routes. One is to run the kit at the bottom of the stated ranges with the 0.3 ohm coil. The other, kinder to delicate recipes, is to fit a mouth-to-lung tank on the mod.

Lost Vape Centaurus BT200 settings on our tasting grid

The Quest X 3.0 chip offers seven modes, which Lost Vape’s own page announces without naming them. Most retailers and published reviews give the same list, namely power, voltage, Turbo, VPC and three temperature control modes. Each one acts on a different moment of the puff.

Setting	What the product pages say	Stage of the grid it affects
Power	5 to 200 W	Mid-palate, the intensity of the puff
Boost Soft, Norm or Hard	Stronger ramp-up in the first seconds	Attack
Voltage	0.7 to 8 V	Mid-palate
VPC, or Curve	Power curve drawn in the app	Attack and finish
Temperature control	SS316, titanium or nickel wire	Finish
Turbo	Boost is not available here	Off the grid, too little detail

Boost, a setting for the attack

Two retailers describe boost in three levels, Soft, Norm and Hard, each strengthening the ramp-up at the start of the draw. On the grid, it is the attack that depends on it. Hard wakes up a coil that is slow to heat, but it can also knock the top notes of a fine recipe out of shape, a white fruit or a custard.

For tasting, Soft is the clearest starting point. It lets the attack build at the recipe’s own pace, so you can judge whether the fruit on the label really opens the puff.

Power, voltage and VPC, the heart of the puff

Power sets the intensity of the mid-palate. On a given coil, a few more watts thicken the vapour and generally pull the notes towards sweetness or toastiness, while lower power keeps them bright. The bottom of each coil’s stated range is the best place for a first reading.

Mostly used by those who already know it, voltage mode runs from 0.7 to 8 V according to the same retailers. VPC, which several pages call Curve, goes further. Its curve is drawn in the app and allows the start and the end of the draw to be set separately, which means the attack and the finish.

Temperature control, a cleaner finish

The SS316, Ti and Ni modes regulate heating on stainless steel, titanium or nickel wire. They need a coil made of that metal, which the kit’s product pages do not state for the UB Max range. Their value to the palate shows at the end of the puff, where capped heating aims to limit the dry note of a wick running short of liquid.

This mode speaks mainly to rebuildable atomiser users, who choose their own wire. With a ready-made coil whose metal is not given, power remains the safest setting.

The Sub Ohm V2 in the kit, a tank built for vapour

The kit pairs the mod with the Centaurus Sub Ohm V2 tank and its UB Max V2 coils, all intended for direct lung vaping. Lost Vape’s pages do not give the same range for each coil, and the gap matters when you set the wattage.

Coil	Range on the mod page	Range on the tank page
UB Max X1 V2, 0.15 ohm	80 to 120 W	80 to 100 W
UB Max X2 V2, 0.2 ohm	60 to 80 W	60 to 80 W
UB Max X3 V2, 0.3 ohm	40 to 60 W	40 to 60 W

Lost Vape therefore publishes two ranges for the same 0.15 ohm coil, 80 to 120 W on the BT200 page and 80 to 100 W on the tank page. For a recipe you want to read, nothing justifies chasing the upper end. The shared range, 80 to 100 W, is the only one both pages agree on.

The 0.3 ohm coil, run between 40 and 60 W, is the best of the three for flavour, the 0.15 ohm being aimed first at vapour volume. Very sweet recipes, such as Dinner Lady’s desserts taken stage by stage, generally gunk up a hard-driven wick faster, which blurs the finish.

The official page lists a 5 or 3 ml tank, and 2 ml for TPD versions. In the UK, refillable tanks are limited to 2 ml, so the TPD version is the one sold on British shelves. Both the airflow and the filling port sit at the top of the tank.

Fitting a tasting tank to the Lost Vape Centaurus BT200

Lost Vape also sells the mod on its own, without a tank, which invites you to fit the atomiser of your choice. Two criteria decide whether the pairing works, the size of the atomiser and the power range of its coils.

The size of the mod

The Lost Vape Centaurus BT200 is 26.9 mm deep according to its official page. An atomiser whose diameter stays under that figure will not overhang the mod, which matters both for balance in the hand and for the look.

The Sub Ohm V2 page itself gives two diameters, 30 and 26.8 mm, without saying which version each one belongs to. Before counting on a flush fit, check the diameter of the tank actually supplied.

The Centaurus Nano MTL, an option from the same house

Lost Vape offers a mouth-to-lung tank in the same family, the Centaurus Nano MTL, presented as compatible with a wide range of 510 mods. Its page gives 7 to 11 W for the 0.8 ohm UB MTL coils and 12 to 17 W for the 1.2 ohm ones, an unusual order, since the lower resistance normally takes the higher wattage. The range printed on the coil is therefore the one to follow, and the BT200, whose range starts at 5 W, covers those wattages either way.

Its page lists 4 ml and does not mention a TPD version. On the UK market, only a tank limited to 2 ml can be sold, so this is worth checking before buying.

This kind of tank suits recipes high in propylene glycol. For Pink Dragon and its 65/35 base, the maker advises against sub-ohm tanks for the 10 ml bottle, which rules out the kit tank in favour of a mouth-to-lung draw. In the UK, nicotine e-liquid is capped at 20 mg/ml and sold in bottles of 10 ml at most.

The app, a settings logbook more than a flavour tool

The app connects to the Lost Vape Centaurus BT200 over Bluetooth 5.1. Two retailers describe it storing three atomiser profiles and setting the VPC curve. For tasting, profiles are the most useful feature, since they keep one setting per atomiser and save rebuilding it at every swap.

The review published by Oneshot Media in September 2025 tempers that appeal. It finds the app mainly useful for wallpapers and usage tracking, notes that Bluetooth drops when the mod is switched off and does not reconnect by itself, and regrets the absence of a Smart mode.

To find a tasting setting again, the mod’s own controls and its 2.4 inch screen are therefore enough. Writing down the wattage and boost level next to each impression mostly helps when comparing two close bottles, for instance two cool recipes from Fighter Fuel taken stage by stage.

FAQ

Five practical questions come up about the mod, beyond flavour settings.

Which batteries does the Centaurus BT200 need?

Two 18650 cells, not supplied with the mod. They are best bought together and used together as a pair. Internal charging goes through a USB-C port, rated for a 5 V and 2 A charger according to the manufacturer.

Which protections does the mod include?

The official page lists four. Short-circuit protection, low battery protection, overheating protection and a cut-off after ten seconds of continuous firing. Cooling is passive, with no fan.

What are the size and weight of the mod?

Two matching sources give 92.9 × 56.9 × 26.9 mm. Lost Vape states a weight of 150 g, give or take 5 g, without batteries. The body combines brushed aluminium alloy and stainless steel.

Which colours are available?

Lost Vape lists five, Pink Purple, Platinum Ridge, Platinum Crest, Silver Carbon and Black Carbon. The colour changes nothing in the electronics or the settings.

What comes in the TPD kit?

The TPD kit holds the mod, the 2 ml Sub Ohm V2 tank, a 2 ml spare glass tube, one 0.15 ohm and one 0.3 ohm coil, a spare parts bag, a USB-C cable and two manuals. No 0.2 ohm coil is included.

Lost Vape Centaurus BT200, a precise base if you choose the tank

Straight out of the box, this mod serves vapour. Set to Soft boost, at the bottom of the ranges and with the 0.3 ohm coil, it already lets a recipe show more clearly. Fitted with a mouth-to-lung tank, it becomes a proper reading tool.

Our verdict is clear. The Lost Vape Centaurus BT200 does not make flavour, it serves it or masks it depending on the tank and the settings you give it. That rule holds for any mod, and it is always the recipe, read stage by stage, that remains the subject of the tasting.

More tasting notes

Tasting notes written for adult readers only. Vaping products can contain nicotine, which is addictive, and vaping products are not for sale to anyone under 18 in the UK. These notes describe equipment and are not a buying recommendation.